DISC Shure PGX14/Beta 98 Wireless System

Full Description

Simply press the channel button on the front of the receiver and it will perform a quick scan of the area and select a clear frequency to avoid any unwanted interference. Once this is done, sync up the receiver with your transmitter by pressing the sync button on the receiver and pointing the infrared port on the transmitter at the receiver.

A maximum of 8 musicians can use PGX Wireless systems in parallel. One wireless system consists of one bodypack transmitter and one receiver.

The design goal of wireless microphone systems is that the user cannot differentiate between a wired or wireless mic. The PGX system uses our patented Audio Reference Companding which makes the system sound more like a wired microphone than ever before, with less noise and greater dynamic range than other wireless systems. No artifacts lower noise floor and clearer sound at all levels.

Features / Specifications:

• 92m operating range
• Multi-color LED indicating power, lockout, mute and low battery
• The frequency Agile UHF design provides up to 90 selectable UHF frequencies that operate on an 18MHz UHF bandwidth
• More than eight hours of continuous use with two AA batteries
• Carrying case included in every system
• Diversity Reception system uses twin receiver circuits to minimise noise and drop out caused by RF interference
• Use up to 8 systems simultaneously
• PGX4 has has XLR and unbalanced 1/4 inch jack audio outputs
• PGX1 includes mute switch and battery power warning lights - 8 hours battery life from 2 x AA 1.5v alkaline batteries

• Compatible systems per frequency band (up to): 8
• Selectable frequencies: 90
• Auto Setup Features: Scan/Sync
• Audio Reference Companding: Yes
• Included Antennas: Attached 1/4-wave
• Antenna Options: No
• Receiver Network Ability: No
• PC Control: No
• Rack Hardware: Optional (URT)
• Case: System Case
• Transmitter Display: Multi-color LED
• Receiver Display: Multi-color LED
• Battery, Endurance: 2AA, >8 h
• Environment: Small to medium stages

• Working Range: 100m (300ft) - actual range depends on RF signal absorption, reflection and interference
• Audio Frequency Response: +/- 2dB, Minimum 45Hz, Maximum 15kHz - overall system frequency depends on microphone element
• Total Harmonic Distortion: Ref. +/- 33kHz deviation, 1kHz tone, 0.5 , typical
• Dynamic Range: >100dB A-weighted
• Operating Temperature Range: -18°C (0°F) to +50°C (+122°F) - battery characteristics may limit this range

• Audio Input Level: -10dBV max. at "mic" gain position, +10dBV max. at 0dB gain position, +20dBV max. at -10dB gain position
• Gain Adjustment Range: 30dB
• Input Impedance: 1MΩ
• RF Transmitter Output: 30mW maximum (dependent on applicable country regulations)
• Dimensions: 108 mm H x 64 mm W x 19 mm D
• Housing: Moulded polycarbonate case
• Power Requirements: 2 AA size alkaline or rechargeable batteries
• Battery Life: >8 hours (alkaline)

• Dimensions: 40 mm H x 181 mm W x 104 mm D
• Housing: ABS
• Audio Output Level (ref.+/-33kHz deviation with 1kHz tone): XLR connector (into 600Ω load): -19dBV, 1/4inch connector (into 3000Ω load): -5dBV
• Output Impedance: XLR connector: 200 Ω, 1/4 inch connector: 1kΩ
• XLR output: Impedance balanced
           - Pin 1: Ground (cable shield)
           - Pin 2: Audio
           - Pin 3: No Audio

• Sensitivity: -105 dBm for 12 dB SINAD, typical
• Image Rejection: >70 dB, typical
• Power Requirements: 12-18 Vdc at 150 mA, supplied by external power supply