DISC Alto Mixpack Portable 600w Powered PA System

Full Description

View Full Description

MIXPACK doesn't stop with professional amplification and speakers. A 10-channel mixer is included so you can connect everything from musical instruments to microphones to an iPod. Maybe your band is gigging or you are a live sound engineer or sound contractor looking for something you can set up quickly without sacrificing quality or power, Regardless of where the performance takes you, MIXPACK is easy to set up with all the right connections. Stands are included so you can get the sound where it needs to go.

Once all your gear is connected to MIXPACK, you can go to work on fine tuning for the venue with MIXPACK's built-in 24-bit digital effects and 7-band graphical EQ. Effects include Hall, Room Vocal & Plate Reverb, Mono & Stereo Delay (max Delay Time 650ms) Chorus, Flanger & Reverb Modulations, Stereo Delay Chorus Rev+Delay and Rev+Chorus combinations. 256 total effects spread across 16 types with 16 variations mean that you are always ready for any room and any performance.

When you need to get in and out in a hurry with high-power, clarity and flexibility, MIXPACK is the portable PA choice of audio professionals. Also available are the 1000W MIXPACK Pro and 350W MIXPACK Express.

Features

• Portable 3-Way Powered PA System
• 12" subwoofer and two 2x6.5" speakers with 600W continuous rated power
• 8-Channel Mixer with digital effects, 7-band graphical EQ and XLR, Line and RCA inputs
• Lightweight, one-piece design for convenient transport
• Microphone cables and speaker cables included

Specifications

• 3-Way Powered System Bi-Amp plus passive crossover into Satellite
• Low Output Power: 150W RMS Class AB
• MID-HIGH-Output Power: 75W+75W RMS Class AB
• Peak Power Rating: 600W Peak
• Maximum SPL @ 1m 116.5dB Continuous: - 119.5dB Peak (calculated)
• Frequency Response: 55Hz-20KHz @ -10dB
• Impedance: Low-Mid/High Low 8ohm - Mid/high 8ohm
• Crossover Frequencies: Active 125Hz at 12dB/Oct - Passive 3000Hz at 12dB/Oct with Electronic Dynamic Protections
• Amplifier Protections: Low-Mid/High Soft start - Short Circuit - DC output voltage - Thermal Protection - Subsonic Filter at 30Hz - 24dB/Oct - Limiter/Compressor
• Low Frequency Device: 12"/318mm - 2" Voice Coil
• Mid Frequency Device: 4?.5"/165mm - 1.5" Voice Coil
• High Frequency Device: 2?"Compression Driver - 1" Voice Coil
• Hom Coverage: H° ?V° 80°H ?80°V
• Plastic Reinforced Cabinet Polypropylene

Mixer Section:

• Microphone Input: Electronically balanced discrete input configuration
• Frequency Response: 10Hz to 55KHz +/-3dB
• Distortion(THD&N): 0.04 at +4dBu 1KHz
• Gain: 35dB
• SNR(Signal to Noise Ratio): ≥94dB
• Line input: Electronically balanced
• Frequency Response: 10Hz to 55KHz +/-3dB
• Distortion(THD&N): 0.04 at +4dBu 1KHz
• Gain: 15dB

Stereo input / Output:

• Line input: Unbalanced
• Frequency Response: 10Hz to 55KHz +/-3dB
• Distortion(THD&N): 0.04 at +4dBu 1KHz

Impedances:

• Microphone Input: 1.4k ohm
• Channel insert retum: 2.5k ohm
• All other lnputs: 10k ohm or greater
• Tape out: 1k ohm
• All other outputs: 120 ohm

Equalisation:

• Hi shelving: ±15dB@12KHz
• Mid bell: ±[email protected]
• Low shelving: ±15dB@80Hz

DSP section:

• A/D and D/A converters: 24bit
• DSP resolution: 24bit
• Type of effects: Reverbs, Stereo, Delay, Chorus, Rev+Delay and Rev+Chorus combinatons
• Presets: 16

Controls & Monitoring:

• 16-position preset selector
• Cllp Led
• Mute Switch with LED indicator

Main Mix Section:

• Noise(Bus noise): Fader 0 dB channels muted -85dB (ref:+4dBu), Fader 0 dB all input channels assigned and set toUnity gain:-81dBr(ref:+4dBu)
• Max output: 27dBu balanced
• Controls: 22dBu balanced 1/4" jacks
• AUX Sends: max out 22dBu
• Power Supply: AC-220/240V or AC-100/120 Volt, with Switching Power Mode.
• Dimensions (WxLxH): 1060mm x 700mm x 700mm